East Timor The Function and Use of Defoaming Agents for Electroplating Wastewater Treatment(3)

feeling

gold

      East Timor Defoaming agents for electroplating wastewater treatment have low surface tension and are insoluble in foaming media. Adding them to electroplating wastewater will not affect chemical substances such as biological bacteria in the water, and will not change the water quality and its basic system. In addition, high temperature resistance, acid and alkali resistance are also important characteristics. Electroplating wastewater contains alkali and other harsh environmental factors. Defoaming agents for electroplating wastewater treatment can quickly adapt to achieve rapid defoaming and long-term foam inhibition. Excellent water solubility can quickly dissolve with wastewater systems, achieving results.

powder

agent

affect

does

black

There is no unified understanding of the mechanism of defoaming agents. According to the mechanism of defoaming agents proposed by predecessors, there are generally the following types: [4]
General defoaming mechanism
Typical defoaming mechanisms with a broad overview are the Robinson defoaming mechanism and the Ross hypothesis. Among them, Robinson mechanism is the basis of Ross hypothesis, which mainly emphasizes the liquid drainage of defoamer destroying foam and Marangoni effect to realize defoaming; The Ross hypothesis is based on the fact that the defoamer particles are insoluble droplets, while some defoamers actually produce defoaming effects in a dissolved state, so the defoaming mechanism of the Ross hypothesis is not comprehensive

hand

    East Timor Chemical foam in electroplating wastewater treatment is due to the existence of many surfactants such as detergent and colloidal organic matter in the wastewater, which have strong foaming ability. Therefore, under the conditions of water flow speed, fall, aeration, blowing off, etc., a large number of small and light white brown foam will appear on the surface of the wastewater, which is unstable. There are still some differences between biological foam and chemical foam in appearance, usually showing soil brown or grayish brown. There are many reasons for this kind of foam, such as the soil brown foam caused by the low dissolved gas in the biochemical tank. Grey brown foam produced by low MLSS. Foam caused by microbial factors such as microbial abnormalities. Filamentous bacteria grow abnormally, mix and accumulate with foaming and floc particles to form foam that is difficult to eliminate, etc. The defoamer for electroplating wastewater treatment uses modified silicon polyether and modified oxane as the main raw materials to eliminate foam. It can achieve good results for chemical foam and biological foam that may appear in the electroplating wastewater system.