Welcome to Dongguan Hongrui Chemical Co., Ltd

Chile The Function and Use of Defoaming Agents for Electroplating Wastewater Treatment(4)

2023-05-17

foam

affect

anti-cratering

black

powder

Elimination of foam
(1) Physical methods
From the physical point of view, the methods to eliminate foam mainly include placing baffle or filter screen, mechanical agitation, static electricity, freezing, heating, steam, radiation, high-speed centrifugation, pressure reduction, high-frequency vibration, instantaneous discharge and ultrasound (acoustic liquid control). These methods promote the gas transmission rate at both ends of the liquid film and the liquid discharge of the bubble film to varying degrees, making the stability factor of foam less than the attenuation factor, As a result, the number of foam gradually decreased. However, the common disadvantage of these methods is that their use is strongly restricted by environmental factors, and the defoaming rate is not high. The advantages are environmental protection and high reuse rate.

titanium

    Chile Chemical foam in electroplating wastewater treatment is due to the existence of many surfactants such as detergent and colloidal organic matter in the wastewater, which have strong foaming ability. Therefore, under the conditions of water flow speed, fall, aeration, blowing off, etc., a large number of small and light white brown foam will appear on the surface of the wastewater, which is unstable. There are still some differences between biological foam and chemical foam in appearance, usually showing soil brown or grayish brown. There are many reasons for this kind of foam, such as the soil brown foam caused by the low dissolved gas in the biochemical tank. Grey brown foam produced by low MLSS. Foam caused by microbial factors such as microbial abnormalities. Filamentous bacteria grow abnormally, mix and accumulate with foaming and floc particles to form foam that is difficult to eliminate, etc. The defoamer for electroplating wastewater treatment uses modified silicon polyether and modified oxane as the main raw materials to eliminate foam. It can achieve good results for chemical foam and biological foam that may appear in the electroplating wastewater system.