Welcome to Dongguan Hongrui Chemical Co., Ltd

Mozambique The Function and Use of Defoaming Agents for Electroplating Wastewater Treatment(3)

2023-04-03

      Mozambique Defoaming agents for electroplating wastewater treatment have low surface tension and are insoluble in foaming media. Adding them to electroplating wastewater will not affect chemical substances such as biological bacteria in the water, and will not change the water quality and its basic system. In addition, high temperature resistance, acid and alkali resistance are also important characteristics. Electroplating wastewater contains alkali and other harsh environmental factors. Defoaming agents for electroplating wastewater treatment can quickly adapt to achieve rapid defoaming and long-term foam inhibition. Excellent water solubility can quickly dissolve with wastewater systems, achieving results.

powder

agent

pigment

anti-delamination

hand

adhesion

Leveling agents are generally divided into two categories. One type of leveling agent works by adjusting the viscosity and leveling time of the paint film. Most of these leveling agents are organic solvents or mixtures with high boiling points, such as isophorone, diacetone alcohol, Solvesso 150, etc; The other is to adjust the surface properties of the paint film to play a role, and generally speaking, leveling agents refer to this type of leveling agent. This type of leveling agent migrates to the surface of the paint film through limited compatibility, affecting surface properties such as interfacial tension of the paint film, and achieving good leveling of the paint film. Depending on the chemical structure, there are three main types of leveling agents: acrylic acids, organosilicon, and fluorocarbon compounds

    Mozambique Chemical foam in electroplating wastewater treatment is due to the existence of many surfactants such as detergent and colloidal organic matter in the wastewater, which have strong foaming ability. Therefore, under the conditions of water flow speed, fall, aeration, blowing off, etc., a large number of small and light white brown foam will appear on the surface of the wastewater, which is unstable. There are still some differences between biological foam and chemical foam in appearance, usually showing soil brown or grayish brown. There are many reasons for this kind of foam, such as the soil brown foam caused by the low dissolved gas in the biochemical tank. Grey brown foam produced by low MLSS. Foam caused by microbial factors such as microbial abnormalities. Filamentous bacteria grow abnormally, mix and accumulate with foaming and floc particles to form foam that is difficult to eliminate, etc. The defoamer for electroplating wastewater treatment uses modified silicon polyether and modified oxane as the main raw materials to eliminate foam. It can achieve good results for chemical foam and biological foam that may appear in the electroplating wastewater system.